Interior · 7 min read
How to Remove Smoke, Pet and Cooking Odors Before You Paint
Paint can seal many odors in, but it is the last step, not the first. Odor that lives in a porous surface needs cleaning and the right primer before any finish coat.
To remove smoke, pet or cooking odors before painting, wash walls, ceilings and trim with a degreasing cleaner, fix or remove the source, let everything dry, seal the surfaces with a stain-blocking primer labeled for odors, then apply finish coats while ventilating. Porous materials that hold the smell may need replacing.
Key takeaways
- Clean the walls, ceilings and trim thoroughly first; paint over residue and the odor often comes back.
- Seal every surface that held the smell with a stain-blocking primer labeled for smoke and odor, then add your finish coats.
- Porous materials like carpet, padding, drywall that was soaked, and bare wood may hold odor that no paint will fix.
- Ventilate throughout and be patient: odors fade as paint cures over weeks.
Jump to a section
Odors are residue. Cigarette smoke leaves a sticky film. Pet accidents soak into porous surfaces. Years of frying leave a thin layer of grease on every surface within reach. Paint sits on top of that layer, so if the layer is still there, so is the smell. Taking the steps in the right order is what makes the difference.
Why do odors stay after I repaint?
Odor molecules cling to soft, porous and sticky surfaces. When the surface is not cleaned, the residue underneath slowly works its way through the paint, especially when the room warms up. In Michigan, the dry winter air from forced heat and the humid air of summer off Lake St. Clair can both change how a room smells, so an odor that seemed gone in February can return in July.
The fix is to remove as much residue as you can, seal what is left, and replace what cannot be cleaned. Paint is one part of that, but not a substitute for it.
How should I clean the room first?
Do the dry work first, then wash from the top down, because dirt and grease run and drip.
- Remove soft goods. Take down curtains and wash or dispose of them. Remove or clean area rugs. Soft furnishings hold smoke and pet odor and will bring it back into a freshly painted room.
- Clean vents, returns and radiators first. Dust and residue collect there, and forced-air vents and returns spread it around when the heat runs. Clean what you can reach before any wet washing, so loosened dust doesn’t land on clean walls.
- Turn off the power, then wash from the top down. Before washing near outlets, switches or ceiling fixtures, shut the room’s power off at the breaker and leave it off until everything is dry; work by daylight or a light on another circuit. Dry-sponge any loose fireplace soot first, because wet washing can smear it. Then wash the ceiling and its fixtures, followed by the walls, using a degreasing cleaner suited to painted surfaces, working in sections with a sponge and clean water for rinsing. Smoke residue often shows as a yellow-brown film on the rinse water. Change the water often, wring the sponge out well, and don’t soak plaster.
- Clean trim, doors and switch plates. These are hand-touched and often missed. Our guide on how to clean painted walls covers cleaners and technique, including how to avoid damaging a delicate finish.
- Rinse and let dry fully. Residual cleaner can affect paint adhesion. Rinse well, and wait until the surface is dry to the touch and the room feels dry before you restore the power or start priming.
In kitchens, grease also needs attention on the ceiling and above the stove, because it rises. Painting kitchens: grease and prep goes into more detail on that room.
What if the source is still there?
Treat the source before you paint, or the odor returns. A few common cases:
- Smoke. If someone is still smoking in the room, a new coat of paint will pick up the odor again. A fireplace that draws poorly can leave soot on the surrounding wall, so have a chimney professional find out why before you repaint. Our guide to painting fireplace mantels and surrounds covers the painting side.
- Pets. Urine soaks into carpet, padding, subfloor and the bottom of drywall and baseboards. Enzyme cleaners made for pet accidents can break down the residue on some surfaces. Always read the label, and test an out-of-sight spot.
- Cooking. A weak or unused range hood leaves grease in the air. Clean the filter and run the fan while you cook. A hood ducted outdoors removes grease vapor; a recirculating hood only catches some of it in a filter that needs regular cleaning or replacing.
- Moisture and mildew. A musty smell is a moisture problem. Clean the mildew, fix the water source and let the area dry before sealing. Painting over damp material just traps the problem.
What primer seals in odors?
After cleaning and drying, a stain-blocking primer labeled for smoke and odor gives you a barrier between residue and finish coats. Shellac-based and oil-based products are commonly used on heavy smoke because they seal tightly, and some waterborne options handle lighter cases. They differ in odor and cleanup, so read the label. Stain-blocking primers explained describes how the three types compare.
Apply the primer to every surface that held the smell: walls, ceilings, and trim as needed. A single coat is often enough on lightly affected surfaces. Heavily smoke-stained areas often take two. Don’t spot-prime a few yellow areas and leave the rest; odor can work its way out through the unsealed parts.
Once the primer has dried, the finish paint goes on in even coats, the same way our interior painting process applies it. If glossy trim is part of the job, a bonding primer may be needed as well; painting over oil-based and glossy paint explains that step.
Painting rooms like this in Grosse Pointe?
Tell us about your home and we’ll be in touch to talk it through.
What will paint not fix?
This is the honest part of the topic. Paint is a thin film over a surface. It cannot reach into the materials behind it. Some odors are deeply held and need removal:
- Carpet and padding that absorbed pet urine or smoke. These are usually replaced rather than treated.
- Subfloor and wood that urine has soaked into may need sealing with a primer made for the purpose, or replacement in severe cases.
- Drywall or insulation that has been soaked, whether by a leak, a flood or repeated accidents, may need to be cut out and replaced.
- Unsealed plaster in a smoky room can hold odor, though cleaning and priming often helps a great deal.
- Heating ducts and vents that circulate the odor. Cleaning the ducts is a job for a heating specialist, not a painter.
If the smell is still strong after a thorough cleaning and a coat of primer, it is better to find the hidden source than to add more paint. Plaster that has been wet and has stains or loose areas is also a repair issue, to be sorted out before any primer goes on.
How should I ventilate while painting?
Ventilation helps with both the odors you are removing and the odors of the primer and paint. Open windows on opposite sides of the room if the weather allows, and keep the air moving through the drying period. With waterborne products, a box fan set in a window blowing outward helps move air. Shellac-based and oil-based primers need extra care because their vapors are flammable: skip fans and other electrical equipment that could spark, keep every flame, pilot light and other ignition source away as the label directs, and take breaks in fresh air.
Cold weather complicates this. In winter you may not be able to leave windows open all day, so the room needs enough warmth for the product to dry and cure properly. Winter interior painting in Michigan covers how to balance fresh air with the label’s minimum temperature. In humid weather, drying slows, so give each coat the time the label asks.
If you are painting a bedroom or a nursery, plan the timing around odors. Painting a bedroom or nursery: odor and timing covers how to schedule so the smell has time to settle before the room is used.
Are there special cautions in older homes?
Yes. Pre-1978 houses may have lead-based paint under the surface. Washing disturbs less paint than scraping or sanding, but it can still loosen flaking paint and dust, and scraping, sanding or scuff-sanding glossy trim before priming can create more, so read the EPA’s Renovation, Repair and Painting program information first. The rule requires certified firms and lead-safe work practices for paid work that generally disturbs more than 6 square feet of painted surface per room inside a pre-1978 home, so if you hire someone for an older house, ask how they handle it. Wet-wipe surfaces and the floor as you clean, use a HEPA-filter vacuum rather than an ordinary household vacuum (which can send fine dust back into the air), and avoid dry sweeping.
Older textured ceilings and plasters can contain asbestos, so have them tested by a qualified professional before scraping, sanding or scrubbing them. If the result is positive, leave the material undisturbed and ask a qualified asbestos professional whether it should be left alone, sealed (encapsulated) or removed. Don’t scrape, sand, roll or spray it yourself. In many older Grosse Pointe and Metro Detroit homes, decades of paint layers on plaster and woodwork can trap a film of smoke or grease, which makes thorough cleaning and a proper primer especially worthwhile.
How long until the smell is gone?
You will notice a fresh-paint smell for days, which is different from the odor you are trying to remove. As the paint dries and cures, that smell fades. Full cure takes weeks, which is why heavy cleaning and scrubbing should wait; paint dry time vs. cure time explains what to expect. If the old odor returns once the paint has cured, something was not sealed or the source is still in the house, so look at soft goods, vents and any areas that missed primer.
If you are not sure how bad the problem is, a plain-English written scope from a painter can spell out cleaning, priming and what is outside paint’s reach. And remember that color samples need to be tested on the primed wall, in the room’s own light, because screens and printed chips mislead.
Questions
Will primer cover cigarette smoke smell?
A stain-blocking primer labeled for smoke can seal in much of the residue, but only after the walls have been washed. Painting over a sticky film often lets the smell come back. In severe cases, soft materials like carpet or soaked drywall may have to be replaced.
Can I paint over pet odors?
Only after the source is dealt with. Urine soaks into porous materials such as carpet padding, subfloor and the base of drywall, and paint cannot reach those. Clean with a cleaner made for pet accidents, replace what is saturated, then prime with a product that suits the surface.
How do I get cooking grease smell off walls before painting?
Wash with a degreasing cleaner, starting at the ceiling and working down, then rinse and let the wall dry fully. Grease prevents paint from bonding, so skipping this step risks peeling. After washing and drying, prime every surface that held the smell with a stain-blocking primer before the finish coats.
About the author
Guiffre's Painting Co.
Family-owned interior painting and plaster repair serving Grosse Pointe and Metro Detroit. Owner Bob Guiffre has been painting for more than 37 years — more than 1,800 homes — and his son, Bobby, works beside him on every project. We paint with Sherwin-Williams. Estimates are free. Insured: $1,000,000 general liability. Call (586) 722-3277.