Request a free estimate Call (586) 722-3277

Older Homes · 7 min read

Painting Mid-Century Ranch and Cape Interiors: Long Walls, Paneling and Textured Ceilings

Ranch interiors look simple, but long walls, big windows and textured ceilings are where lap marks and patchy finishes show up.

Post-war ranches and Capes come with their own challenges: long open walls, strong light from picture windows, wood paneling, hollow-core doors and textured ceilings. A careful job keeps a wet edge, checks walls in raking light, primes paneling and patches, and tests textured ceilings before disturbing them.

Key takeaways

  • Long uninterrupted walls need a wet edge and enough paint to finish a whole wall without stopping.
  • Picture windows create strong side light, which exposes lap marks, patches and sheen differences.
  • Textured ceilings in homes of this era may contain asbestos, so test before scraping, sanding, taping or even rolling them, and leave a positive or untested ceiling alone.
  • Wood paneling and hollow-core doors can be painted well if they are cleaned, sanded and primed with the right products.

Sherwin-Williams colors in this guide

Jump to a section
  1. What makes ranch and Cape interiors different?
  2. How do you avoid lap marks on long walls?
  3. How do picture windows change the job?
  4. What about textured and sprayed ceilings?
  5. Can wood paneling and hollow-core doors be painted well?
  6. How do colors flow through an open plan?
  7. What does careful work look like on a ranch interior?
  8. Questions

What makes ranch and Cape interiors different?

After World War II, ranches (late 1940s into the 1950s) and center-entrance Colonials and Capes were built across Grosse Pointe and Metro Detroit. Compared with the 1920s period revivals, many are simpler inside.

  • Open or semi-open plans, with the living, dining and kitchen areas flowing together
  • Long, flat walls with fewer breaks for corners and trim
  • Large picture windows and sliding doors
  • Simpler, narrower trim, often a plain casing and baseboard
  • Hollow-core interior doors, sometimes flush rather than paneled
  • Wood paneling in dens and basements, and sometimes in main rooms
  • Textured or sprayed ceilings, and drywall or plaster depending on the builder and year

The walls may be drywall, plaster or a mix. If you are not sure, our guide on how to tell plaster from drywall shows how to check, because it changes the repair and primer.

One caution applies to most of what follows. A ranch or Cape built before 1978 may have lead paint on its trim, doors, paneling and window frames, and older joint compounds and textured ceilings may contain asbestos. Scraping, sanding, scuff-sanding and wire-brushing can release that dust, so have suspect surfaces tested first. If asbestos turns up, leave the material undisturbed and talk to a qualified asbestos professional about whether to leave it, seal (encapsulate) it or remove it; do not scrape, sand, roll or spray it yourself. For lead dust, wet-wipe surfaces and use a vacuum with a HEPA filter rather than an ordinary household vacuum or dry sweeping. The EPA’s Renovation, Repair and Painting (RRP) rule requires certified firms and lead-safe work practices for paid work that generally disturbs more than 6 square feet of painted surface per room inside a pre-1978 home.

How do you avoid lap marks on long walls?

Lap marks are the darker bands where fresh paint overlaps paint that has already started to dry. A long wall in a bright room is where they show the most.

  1. Keep a wet edge. Roll in sections from top to bottom and always overlap into wet paint, never dry paint.
  2. Cut in and roll together. Brushed edges that dry before the roller reaches them show as a frame. Cut in a section and roll it right away.
  3. Load enough paint. A roller that is running dry leaves thin streaks. Reload often.
  4. Finish whole walls. Stop at a corner, doorway or trim line, not in the middle of a wall.
  5. Use the same batch. Mix cans together for one wall so slight color differences do not show.
  6. Keep the sheen consistent. Patches in a different sheen read as shiny or dull spots.

Conditions matter too. Heated indoor air, direct sun through a picture window and a fan blowing across the wall all dry paint faster and shorten your wet-edge time. Shut off drafts, keep the sun off the wall if you can, and resist going back over a section once it starts to tack up.

Fresh patches should be primed, or they flash and look like a dull rectangle in raking light. Our guide on how to touch up paint covers touch-ups, and the paint sheen guide explains why sheen differences show.

How do picture windows change the job?

A large window throws strong light across the room, and light that skims along a wall reveals every roller mark, patch and bump. Good painters check walls in that light before the finish coat.

  • Look at the wall during the time of day when the window light is strongest.
  • Use a flashlight held flat to the wall to see ridges from patches and sanding.
  • Choose flat or eggshell on walls opposite big windows to reduce glare. Higher sheen shows more flaws.
  • Test paint colors in the room’s actual light. A west-facing picture window gives warm late light, while north light looks cooler and grayer. Our guide on how light direction changes interior paint color explains each exposure.

Keep paint off window frames, weatherstripping and sliding-door tracks, and mask them carefully before cutting in.

Large panes run cold in a Michigan winter, and condensation on the glass and sill can streak or soften paint at the bottom of the window. Wipe it off regularly, and address the moisture before repainting a sill that keeps peeling.

Painting rooms like this in Grosse Pointe?

Tell us about your home and we’ll be in touch to talk it through.

Request a free estimate

What about textured and sprayed ceilings?

Ceilings in some ranches have a sprayed or popcorn texture, which may be original or added in a later remodel. Painting it is different from removing it.

Test before disturbing. Textured ceilings and joint compounds in older homes may contain asbestos. The EPA’s Learn About Asbestos page lists textured paint and patching compounds used on walls and ceilings among the places asbestos may be found, and says fibers can be released when the material is disturbed. Scraping and sanding disturb them, and so do rolling, cutting in and taping, so if the texture is old, flaking or of unknown age, treat it as suspect and have it tested before any of those steps. Do not disturb a ceiling you have not tested, and stop and call a professional if the texture starts to crumble.

If the test is positive, or the ceiling has not been tested, leave it undisturbed: no scraping, sanding, rolling, spraying or taping. Talk to a qualified asbestos professional about whether to leave it, seal (encapsulate) it or remove it, and do any painting only on their advice. The EPA’s homeowner guidance on asbestos likewise says to treat suspect material as asbestos-containing and leave it alone, and to have a trained, accredited professional take any samples, since incorrect sampling can be more hazardous.

If the test is negative and the texture is sound, painting it is generally a matter of a thick-nap roller, flat ceiling paint, and a gentle touch, since heavy rolling can loosen the texture. Water stains need a stain-blocking primer, and the leak itself must be fixed first.

On a ceiling that has tested clean, cutting in against texture is the hard part, because the brush line looks fuzzy and masking tape can pull flakes of texture or paint away, which is one more reason to test first. A steady hand with an angled brush, and a check of the line from the floor, usually gives a cleaner result than tape. Our painting ceilings guide covers the general approach, and painting textured walls and ceilings goes further.

Can wood paneling and hollow-core doors be painted well?

Yes, with the right prep.

  • Paneling. Clean it first, since grime and wax are common, switching the power off at the breaker before washing near outlets, switches or fixtures. Let it dry, then scuff-sand and use a bonding primer over glossy finishes. Knots and tannins can bleed, so a stain-blocking primer is often used. After priming, decide about the grooves between panels: fill or caulk them for a smooth wall, or keep them as a design feature, then spot-prime any filled areas before the finish coats. If the paneling is a thin veneer or has a printed woodgrain, sand very lightly, because sanding through shows the layer beneath. See painting knotty pine and wood paneling.
  • Hollow-core doors. They are light and flat, so thin coats matter most. Remove hardware, clean the door, scuff-sand lightly, prime with a bonding primer where the surface is slick, and keep the coats thin to avoid sags on the large flat face. The thin skins can swell if soaked, so seal the top and bottom edges.
  • Trim. Narrow casings and baseboards are quick to paint but easy to rush. Old enamel on post-war trim may have gone glossy or yellowed, so clean and scuff-sand it, and check the label for a bonding primer. Caulk the top of baseboards, sand between coats and keep the sheen consistent.

Taking paneling down is usually carpentry, and what is behind it varies, so decide before painting whether the paneling stays.

How do colors flow through an open plan?

In a ranch with connected living, dining and kitchen areas, you often see two or three rooms at once. That makes the transitions the hard part. A color change should stop at an inside corner, a doorway or a trim line, not in the middle of a flat wall, or it looks like a mistake.

  • Choose one main wall color and one trim color for the whole open area, then add contrast with a single accent wall at most.
  • Check how the color looks from the far end of the space as well as up close.
  • Test a large sample board in two places and look at it morning, midday and evening, with the lights on after dark.

What does careful work look like on a ranch interior?

  1. No lap marks on long walls in side light
  2. Patches primed and invisible in raking light
  3. Ceiling lines straight, with no roller marks on the ceiling
  4. Window and door frames free of paint on glass and weatherstripping
  5. Even sheen from one end of a wall to the other
  6. Hollow-core doors without sags on the large flat face

Guiffre’s Painting Co. protects floors, furniture and plants, cleans surfaces, scrapes loose paint, sands edges, fills holes and cracks, caulks joints and primes bare or stained areas, then paints with Sherwin-Williams in even coats. Bob and Bobby work on every project, and a final walkthrough with touch-ups closes it out, as described on our process page. Read more on our interior painting page.

Questions

How do I stop lap marks on a long ranch wall?

Keep a wet edge by rolling in sections and always overlapping into wet paint. Cut in and roll one section at a time, load the roller often, and stop only at a corner or trim line. Using flat or eggshell sheen also hides lap marks better than higher sheen.

Is it safe to scrape a popcorn ceiling in a 1950s house?

Not before testing. Textured ceilings and compounds in older homes may contain asbestos, so have a sample tested before scraping, sanding, taping or rolling, especially if the texture is old or flaking. If the result is positive, or you have not tested, leave the ceiling undisturbed and ask a qualified asbestos professional whether to leave it, seal it or remove it; do not scrape, sand, roll or spray it yourself. Only a ceiling that tests clean and is sound should be rolled, gently, and you should stop if it starts to flake.

Can I paint wood paneling instead of removing it?

Yes. Clean it, scuff-sand it and use a bonding primer, and a stain-blocking primer where knots or tannins may bleed. After priming, decide whether to fill the grooves for a smooth wall or leave them visible.

Painting an older home in the Pointes?Plaster, original trim and old woodwork need a careful approach. Here’s ours.

About the author

Guiffre's Painting Co.

Family-owned interior painting and plaster repair serving Grosse Pointe and Metro Detroit. Owner Bob Guiffre has been painting for more than 37 years — more than 1,800 homes — and his son, Bobby, works beside him on every project. We paint with Sherwin-Williams. Estimates are free. Insured: $1,000,000 general liability. Call (586) 722-3277.

Let’s talk about your home.

Tell us a little about the project and we’ll be in touch to talk it through and set a time to see it. Estimates are free.

Request a free estimate Call